From cbfsb!att!att!dptg!ulysses!allegra!princeton!rutgers!sun-barr!ames!agate!stanford.edu!morrow.stanford.edu!pst Mon Jul 27 17:43:28 EDT 1992
Article: 3525 of rec.radio.amateur.packet
Path: cbfsb!att!att!dptg!ulysses!allegra!princeton!rutgers!sun-barr!ames!agate!stanford.edu!morrow.stanford.edu!pst
From: pst@cisco.com (Paul Traina)
Newsgroups: rec.radio.amateur.packet
Subject: Re: 9600 baud mod for Alinco 110, 112, 1200 radios
Message-ID: <PST.92Jul26125156@lager.cisco.com>
Date: 26 Jul 92 20:51:55 GMT
References: <1992Jul26.043534.23205@cbfsb.cb.att.com>
Sender: news@morrow.stanford.edu (News Service)
Organization: cisco Systems, Menlo Park, California
Lines: 20
In-Reply-To: wa2ise@cbnewsb.cb.att.com's message of Sun, 26 Jul 1992 04: 35:34 GMT

I have made this mod, and I have the following suggestions:
(a) you can get a "map" of the board via FAX or snail mail from Alinco
    -- this helps a LOT (it's impossible to read component labels) --
    Alinco is in Torrance Calif, in the phone directory.
(b) Throw away C40, it is impossible for a mere mortal to do what they
    are suggesting.  Replace that SMT C40 with an axial .01uf cap
    (non-polarized, anything kind you want, I used a tant.) and some
    insulation tubing over the leads (it needs to stretch 2 inches
    across the bottom of the pcb.

Alinco claims this mod makes 1200bps unusable, untrue, I use my modded
1200 on both 1200 and 9600 bps without noticable degredation of
performance.

Regards,
Paul