Last updated: 27-September-2011

- Version: 7.04.005
- Build: 7.4.36.05
- This build was done on ati_pcie_integration_jammer
- FPGA Version: (Albatross): 2.86
- Firmware version         : Version 2.7
- Condor PLD version       : Version 1.0 
- Platform Version         : 1.10.1004
- AgtUSBManager            : 3.7
- QuickTests               : 9
- Update GUI               : Version 3.0

ENHANCEMENTS:
  - Windows 7 (32-bit, 64-bit) support
  

IMPORTANT USAGE NOTES:

- If you want to use the software on a system with XP SP2, and you several USB Devices (N5308) attached to your system but only 
  one or none of them gets a valid module number (they start at 10001), this might be due to a problem with loopback addresses in Windows. 
  This has been fixed by Microsoft in the patch KB893066.
  You can get this from: http://www.microsoft.com/downloads/details.aspx?familyid=81049A86-6F39-4A27-A643-391262785CF3&displaylang=en

- If you get an error message 'Error Number: 0x80040704 Description: DLL function call resulted in bad stack. Possible incorrect prototyping: LanDeviceManager.GetLandDeviceProperty' while the installtion does the last steps (from the dialog where you have two checkboxes 'View Readme.txt' and 'Run USB Network Adapter COnfig Helper', please install the Microsoft patch 935448 from 
          http://support.microsoft.com/kb/935448/en-us

- If you get an error message: 
          The system DLL user32.dll was relocated in memory. The application will not run properly. The relocation occurred because the DLL C:\Windows\System32\Hhctrl.ocx occupied an address range reserved for Windows system DLLs. The vendor supplying the DLL should be contacted for a new DLL.
          please install the Microsoft patch 935448 from 
          http://support.microsoft.com/kb/935448/en-us

- To run the Quicktests: 
	1.) Connect a session through GUI.
	2.) In the Toolbar of Jammer GUI, click on the Quicktest button.
	3.) In the pop up window, select session type as PCIEJammer
	4.) Go to Tests -> Select the testcase you want to execute.
	5.) Press the Load button on the Toolbar
	6.) On the pop up window, you can the read the description of test under description Tab.
	7.) Go to Configure Test Tab and select the Time and Side parameters. Time parameter tells in minutes how long the test should execute. The Side parameter tells in which side the Error should be inserted.
	8.) Press the Start test button at Bottom Right side.
	9.) See the Report under Report Tab after testcase finishes.