![]() | ||||
![]() |
HP 5087A Distribution Amplifier![]()
|
The modular HP 5087A design lets you structure the product for a variety of distribution needs. Special combinations of input and output modules are available.
Inputs (Up to three, rear-panel BNC) Frequencies: 10 MHz, 5 MHz, 1 MHz, or 100 kHz Level: 0.3 to 3.0 V rms, 50 ohms Harmonic distortion: >40 dB below rated output Nonharmonic distortion: >80 dB below rated output Outputs (Up to 12 rear-panel BNC) Frequencies: 10 MHz, 5 MHz, 1 MHz, or 100 kHz Level: 0 to 3 V into 50 ohm (screwdriver adjustment) Isolation Load (open or short on any other channel): Amplitude change: 0.1% Phase change: <0.1 ns at 5 or 10 MHz <0.5 ns at 1 MHz <5.0 ns at 100 kHz Injected signal: 1 V signal up to 50 MHz applied to any output except 10 MHz, will be down >60 dB in all other outputs; 10 MHz output channel will be down >50 dB. SSB Phase Noise (5 MHz): <145 dB below signal in 1 Hz BW for frequencies <1 kHz from carrier Stability Amplitude: ±0.5 dB, 0 degrees to 50 degrees C Phase: <0.1 ns/degree C, 5 and 10 MHz Humidity: 95% at 40 degrees C Altitude: Up to 30,000 ft
HP 5087A Distribution Amplifier Mainframe Opt 001 5 MHz output amplifier Opt 002 1 MHz output amplifier Opt 003 0.1 MHz output amplifier Opt 004 Input preamplifier (0.1 to 10 MHz) Opt 005 5 to 1 MHz input divider Opt 006 1 to 0.1 MHz input divider Opt 011 5 to 10 MHz input doubler Opt 012 10 MHz output amplifier Opt 013 10 to 5 MHz input divider Opt 014 10 to 1 MHz input divider Opt 031 5, 1, 0.1 MHz inputs; 4 outputs at each Opt 032 Single 5 MHz input and 12 outputs Opt 033 Single 10 MHz input and 12 outputs Opt 034 Single 5 MHz input, 4 each; outputs at 5, 1, and 0.1 MHz Opt 908 Rack Flange Kit
No literature is available online at this time.
Related Information:
HP E1752A VXI Pulse Distribution Amplifier The HP E1752A pulse distribution amplifier is a C-size, 1-slot, register-based VXI module.
HP 59552A Fiber Optic Distribution Amplifier The HP 59552A Fiber Optic Distribution Amplifier provides a simple, modular approach to signal routing.
HP 59553A Fiber Optic Receiver The HP 59553A Fiber Optic Receiver is located at remote equipment installations to receive a distributed signal from a common clock.
Related Distribution Amplifiers product datasheets:
Page Updated: Thursday February 18 09:03:05 UTC 1999