NAIMIO16 Analog I/O Board

The NAIMIO16 Analog I/O Board adds analog I/O to an HP OpenRobot Controller. It connects directly to an Analog Devices carrier board providing a wide range of I/O including voltage, current, RTD, thermocouples, strain gauges, and frequency inputs.

[ Features ]

16 analog inputs
2 analog outputs
Directly connects to Analog Devices 5B01 carrier board (board & isolators are not included)

[ Specifications ]

User

Analog inputs 16 Analog outputs 2 Resolution 12 bits Channel-independent gains and ranges on inputs Software calibration User selectable interrupts IRQ 3-15

Input Characteristics

Voltage ± 11V signal + common mode

Sampling rate 100 kHz max

Accuracy Undithered ± 2 LSB max.

Output Characteristics

Update rate 100 kHz max Voltage ± 11V Accuracy Calibrated ± 0.3 LSB typ. ± 0.5 LSB max Uncalibrated ± 4 LSB max.

Impedance 0.1 Ohm max.

Current drive ± 5 mA

Protection SC - grd

Environmental

Temperature 0 - 55° C

Humidity 5 - 90% non-condensing

Power 5 V (± 5%) 700 mA

Dimensions 338mm (L)x 99mm (H) Mass 500 g

[ Ordering ]

NAIMIO16 NAIMIO16 Analog I/O Board

----Available in North America Only---- To help you make the right controller choices, Your Sales Engineer is ready to answer your questions about specifications, applications and ordering. Call the OpenRobot Help Desk at 248.844.0555 or email us at "openrobotsales@hp.com". Do you require hardware or software technical support? OpenRobot technical support is available at 248.844.0555 or email us at "openrobotsupport@hp.com".

All orders include the following:
1 - National Instruments AT-MIO-16E-10 analog I/O board 1 - I/O cable, 1m, 68-50 pin 1 - NAIMIO16 driver

[ Key Literature ]

No literature is available online at this time.

[ Assistance ]

To help you make the right product choices

Local Sales Office

[ Related ]

Related Information:

HP OpenRobot I/O Boards

Related product families available online:

HP OpenRobot Controller