PRO-2026 100-Channel Mobile Programmable Scanner
(200-0148B)                 Troubleshooting            Faxback Doc. # 16904

IF YOU HAVE PROBLEMS...

Here are some suggestions which might help.

PROBLEM             POSSIBLE CAUSE              REMEDY

Scanner does not    The power connection is     Secure the connection
operate at all.     loose or the red power      or replace the fuse.  See
                    wire's fuse is blown.       "Replacing the Fuse."

Scanner is on but   The SQUELCH control is      Adjust the SQUELCH
does not scan.      not correctly adjusted.     control clockwise.

In the scan mode,   "Birdies"                   Avoid programming fre- 
the scanner stops                               quencies listed under
on frequencies that                             "Birdies."
have an unclear
transmission.

The keys are in-    The CPU is locked up.       Reset the scanner.  See
operative or the                                "Initializing/Resetting
scanner displays                                the Scanner."
random segments.

REPLACING A FUSE

If the scanner does not operate, you might need to replace the red power
wire's fuse.

NOTE:  Also check your vehicle's fuses.

Use the following steps to check/change a fuse.

WARNING:  Before you begin, turn off the scanner and your vehicle's
          ignition.

1.  Disconnect the red power wire.

2.  Push and twist the fuse holder so that it springs apart.

3.  If the fuse is blown, replace it.  Use only standard 30 mm, 1-amp
    fuses.

4.  Reassemble the fuse holder by pushing and twisting the two parts until
    they snap together.

5.  Reconnect the red power wire to the ACC terminal.

Privacy Policy