PRO-2023 Programmable Scanner
(200-0128)       Searching for Active Frequencies     Faxback Doc. # 18516

Use this procedure to search for a transmission within a range of
frequencies.  You must set the frequency range within each band listed
below.  That is, you cannot set the upper and lower frequencies in
different bands.  For example, if you set the lower frequency to 30 MHz and
set the upper frequency at 110 MHz, the scanner does not accept the entry
and the display shows ERROR.

     29 MHz to  54 MHz (VHF Lo)
    108 MHz to 136 MHz (Air)
136.005 MHz to 174 MHz (VHF Hi)
    406 MHz to 512 MHz (UHF)

When you find an interesting frequency, you can store the frequence in the
monitor memory and later move it to a channel.

1.  Press [PROGRAM].

2.  Press [LIMIT].

3.  Enter the lower limit of the frequency range.

4.  Press [ENTER].  Then, press [LIMIT].

5.  Enter the upper limit of the frequency range.

6.  Press [ENTER].

7.  Press down-arrow to search from the upper limit down to the lower
    limit.  Or, press the up-arrow to search upward starting from the lower
    limit.

8.  When the scanner stops on a transmission, press [MONITOR] to store the
    frequency in the monitor memory.  Or, press the up-arrow or down-arrow
    to continue the search.

NOTE:  Press [DELAY] to make the scanner pause 2 seconds after a
       transmission before proceeding to the next frequency.


(12/15/95)

Privacy Policy