PRO-27
(200-0108)                 Preparation                Faxback Doc. # 39654


INSTALLING THE CRYSTALS

The crystals are not provided with your PRO-27 monitor/receiver because
different locations determine which frequencies are available.  Also,
each individual decides which frequencies are of greatest interest.

You can choose one for the UHF band and one for the VHF Hi band.  Or,
you can choose two separate frequencies in the same band.  Radio Shack
can help you find the correct crystals for the frequencies of your
choice.

Press down on the battery compartment cover and slide it off in the
direction of the arrow.

The receptacles for the two crystals are designated in the illustration
as A and B.  Insert the crystals into the receptacles.  Set the
corresponding Band Selector switch to coincide with the band in which
the crystal's frequency is found (U for UHF and V for VHF Hi.)

Because crystal frequencies must be extremely accurate, we recommend that
you obtain crystals for your pocket receiver only at Radio Shack.  Be sure
to specify the catalog number and model name of your unit.  We cannot be
responsible for the poor or improper operation of crystals obtained from
any other manufacturer.


INSTALLING THE BATTERY

Lift the battery snap out of the compartment.  Snap a 9-volt battery
over the battery contacts.  We recommend Radio Shack's 23-553 Alkaline
Battery or 23-583 Extra-Life.  Place the battery in the compartment and
replace the cover.


ATTACHING THE BELT CLIP
Through the slots on the back of the receiver slide the belt clip upward
until it locks into place.


CONNECTING THE ANTENNA

Screw the flexible (rubber ducky) antenna into the ANT connector on top
of the receiver.


CONNECTING THE EARPHONE

An earphone (optional) can be connected to the EAR jack on top of the
unit.  Radio Shack's mini plug earphone Cat. No. 33-175 fits this jack.

(LB/km-05/20/1997)

Privacy Policy