PRO-2056 50-Channel Home/Mobile Scanner
(200-0147)                 Care and Maintenance       Faxback Doc. # 39992


Your RadioShack PRO-2056 50-Channel Home/Mobile Scanner is an example of
superior design and craftsmanship.  The following suggestions will help
you care for your scanner so you can enjoy it for years.

   Keep the scanner dry.  If it gets wet, wipe it dry immediately.  Liquids
   might contain minerals that can corrode the electronic circuits.

   Keep the scanner away from dust and dirt, which can cause premature wear
   of parts.

   Handle the scanner gently and carefully.  Dropping it can damage circuit
   boards and cases and can cause the scanner to work improperly.

   Wipe the scanner with a damp cloth occasionally to keep it looking new.
   Do not use harsh chemicals, cleaning solvents, or strong detergents to
   clean the scanner.

Modifying or tampering with the scanner's internal components can cause a
malfunction and might invalidate your scanner's warranty and void your
FCC authorization to operate it.  If your scanner is not performing as it
should, take it to your local RadioShack store for assistance.

REPLACING THE FUSES

The fuses in the scanner's DC power cord and DC cigarette-lighter power
cord help protect your scanner from power surges and short circuits.  If the
fuse in the DC power cord has blown, replace it with a 1-amp, fast-acting
glass fuse (such as RadioShack Cat. No. 270-1005).  For the fuse in the DC
cigarette-lighter power cord, replace it with a 2-amp, fast-acting glass
fuse (such as RadioShack Cat. No. 270-1007).

Warnings:

   Before you begin, turn off the scanner and your vehicle's ignition.

   Make sure you replace the fuse only with another fuse of the same type
   and rating.

Replacing the Fuse in the DC Power Cord

1.  Turn off the scanner and your vehicle's ignition.

2.  To open the fuse holder, push the fuse holder ends together, then turn
    either end counterclockwise and release it.

3.  If the fuse is blown, replace it.

4.  To close the fuse holder, push the fuse hold ends together, then turn
    either end clockwise.

Replacing the Fuse in the DC Cigarette-Lighter Power Cord

1.  Turn off the scanner and your vehicle's ignition.

2.  To open the cigarette-lighter plug, turn the cap counterclockwise and
    remove it.

3.  If the fuse is blown, replace it.

4.  Replace the cap.

(km-06/112/1997)

Privacy Policy