PRO-2030 80-Channel Direct Entry Programmable Scanner
(200-0407)                 Preparation                Faxback Doc. # 45539

CONNECTING POWER

CAUTION:  Use only the supplied AC adapter.  Using a different adapter can
          damage your scanner and could present a safety hazard.

Follow these steps to power your scanner.

1.  Plug the provided AC adapter's plug into the scanner's DC 12V jack.

2.  Plug the adapter's power module into a standard AC outlet.

The memory backup circuit begins to function a few minutes after you plug
in the scanner.  If a power failure occurs or if the power cord is
disconnected, this circuit stores information in the scanner's memory for
up to three days.

CONNECTING THE ANTENNA

To attach the supplied telescoping antenna, screw it into the hole on the
top of your scanner.

The antenna's length controls its sensitivity.  Adjust the length of the
telescoping antenna as follows for best reception.

29-54 MHz ....................... Extend Fully (3 segments)
                                  

108-174 MHz ..................... Extend 2 segments
 

380-512 MHz ..................... Collapse Fully (1 segment only)
                                 

806-956 MHz ..................... Collapse Fully (1 segment only)

CONNECTING AN OPTIONAL ANTENNA

The telescoping antenna is adequate for strong local signals.  For best
results, attach a multi-band outdoor antenna (not supplied to the scanner.
Your local RadioShack store sells a complete line of outdoor antennas.

Follow these steps to install an outdoor antenna.

1.  Select a location as high as possible.

2.  Mount the antenna following the instructions that come with the
    antenna and its mounting hardware.

3.  Plug the antenna into the scanner's ANT jack on the rear of the
    scanner using 50 Ohm coaxial cable (RG-58, RG-8/M or RG-8, not
    supplied).  For lengths over 50 feet, use RG-8/M or RG-8 low loss,
    coaxial cable.

Note:  This scanner uses a BNC antenna connector.  You may need an antenna
       adapter, such as Cat. No. 278-120 to use other antennas.

WARNING:  When installing or removing an outdoor antenna, use extreme
          caution.  If the antenna starts to fall, let it go!  It could
          contact overhead power lines.  IF THE ANTENNA TOUCHES THE POWER
          LINE, CONTACT WITH THE ANTENNA, MAST, CABLE, OR GUY WIRES CAN
          CAUSE ELECTROCUTION AND DEATH!  Call the power company to remove
          the antenna.  Do not attempt to do so yourself.

CONNECTING AN EXTERNAL SPEAKER

In a noisy area, an extension speaker, such as RadioShack Cat. No. 21-549,
positioned in the right place, might provide more comfortable listening.

Plug the speaker cable's 1/8-inch (3.5 mm) mini plug into the EXT SP jack
on the back of the scanner.  This automatically disconnect the internal
speaker.

RESETTING AND INITIALIZING THE SCANNER

If the scanner's display locks up or does not work properly after you
connect the power source, you might have to reset the scanner's display
or initialize the scanner.

Follow these steps to reset the display.

1.  Press POWER to turn on the scanner.

2.  Press RESET on the back of the scanner using a pointed object, such as
    a ball-point pen.

3.  Press POWER to turn on the scanner.

If this is not effective, initialize the scanner as directed below.

CAUTION:  Initialize the scanner only when you are sure it is not working
          properly.  This procedure clears all information you have
          programmed into the scanner.

1.  Press POWER to turn on the scanner.

2.  Press and hold CLEAR and then press RESET on the back of the scanner
    using a pointed object, such as a ball-point pen.

3.  Press POWER to turn on the scanner.

(LB/tc 4/9/98)