PRO-74 100-Channel VHF/UHF/Air/800 MHz Race Scanner
(200-0513A) Troubleshooting Faxback Doc. # 60421
If you have problems, here are some suggestions that might help. If none
do, take your scanner to your local RadioShack store for assistance.
Problem Possible Cause Remedy
Keys do not work or Undetermined error. Reset the scanner (see
display changes at "Resetting the Scanner"
random. below).
Scanner is on but will SQUELCH is not cor- Adjust SQUELCH clockwise.
not scan. rectly adjusted.
Only one channel or Store frequencies into
no channels are more than one channel.
stored.
Scanner is totally No power. Check the batteries or
inoperative. make sure the scanner is
plugged into a working AC
or DC outlet.
Be sure the adapter's
barrel plug is fully
plugged into the POWER
jack.
Recharge the rechargeable
batteries or replace the
non-rechargeable
batteries.
The scanner's display Batteries are not Make sure the batteries
dims or the scanner correctly installed. are installed with the
sounds a tone every proper polarity (+ to +
15-30 seconds. and - to -).
Batteries are low. Recharge the rechargeable
batteries or replace the
non-rechargeable
batteries.
Keypad does not work. The keylock function To turn off the keylock,
is activated. press KEYLOCK until K/L
disappears.
BATT Lo appears. The batteries are Recharge rechargeable
weak. batteries, or replace non
rechargeable batteries.
Poor or no reception. Batteries are weak Check the batteries, or
or dead. make sure the scanner is
plugged into a working AC
or DC outlet.
Error appears. Frequency entered Re-enter the frequency
incorrectly. correctly, including the
decimal point.
While scanning, the Stored frequencies Avoid storing frequencies
scanner locks on freq- are the same as listed under "Birdie
uencies that have an "birdie" frequencies. Frequencies" in Faxback
unclear transmission. Doc. # 60420, or only
listen to them manually.
Resetting The Scanner
If the scanner's display locks up or does not work properly after you
connect power, you might need to reset the scanner.
Caution: This procedure clears all the information you have stored into
the scanner (such as frequencies and car numbers). Before you
reset the scanner, try turning it off and on to see if it begins
working properly. Reset the scanner only when you are sure it is
not working properly.
1. Turn off the scanner.
2. While you hold down the 2 and 9 keys, turn on the scanner.
If you still have problems after resetting the scanner, take it to your
local RadioShack store.
(BR EB 7/7/00)
Privacy Policy