Pro-2052: Program Trunked Frequencies

In this tutorial, you will be shown how to store a frequency into your scanner. Before you program your scanner to track a trunked system, consider the following:

Valid trunked system frequencies are as shown below:
Motorola System:
935.0125-939.9875 MHz (in 12.5 kHz steps)
851.0000-868.9875 MHz (in 12.5 kHz steps)
406.0000-512.0000 MHz (in 12.5 kHz steps)
137.0000-174.0000 MHz (in 5 kHz steps)
Ericsson EDACS system:
900.0000-956.0000 MHz (in 12.5 kHz steps)
806.0000-899.9875 MHz (in 12.5 kHz steps, except cellular frequencies)
406.0000-512.0000 MHz (in 12.5 kHz steps)
137.0000-174.0000 MHz (in 5 kHz steps)
You can use any of your scanner's banks as either a trunk scanning bank or conventional scanning bank, but you cannot mix the two.
The scanner only scans one trunked system at a time. Although you can store frequencies for more than one trunked system in one of your scanner's banks, the scanner only scans the frequencies associated with the first data channel it finds.

Before scanning a trunked system's transmissions, you must store the trunked system's frequencies in one of the banks in your scanner by following these steps:

For additional information on this product, see the links below:

Step 1: Initiate Scanning Mode

Pro-2052 bank1-20 1ch 866.1625 scan

Pro-2052 keypad/scan

Set the scanner for conventional scanning by pressing SCAN.

Step 2: Initiate Trunk Mode

Hold down TRUNK until the scanner beeps twice. BANK, TRUNK, and the bank numbers flash.

Step 3: Select a Bank

Press a number key to select the bank for the trunked system's frequencies. To select a bank between 11 and 20, press SHIFT then the number keys. The scanner displays one on of six system types.

Step 4: Select a System Type

Use the UP or DOWN arrow keys to select the system type, then press E.

You see	Trunk System
E1	Motorola Type I, 800 MHz frequencies
Ed	EDACS frequencies
E2-UHF	Motorola Type II, UHF frequencies
E2-Hi	Motorola Type II VHF frequencies
E2-800	Motorola Type II, 800 MHz frequencies
E2-900	Motorola Type II, 900 MHz frequencies

Step 5: Enter the Trunked System's Frequencies

Use the number keys to enter the trunked system's frequencies, then press E.

Note: If you entered an invalid frequency, the scanner beeps, the channel number flashes and ERROR appears. Press CLEAR to clear the frequency, then repeat Step 5.

Step 6: Select Additional Channels

Press either MANUAL or the UP arrow key to select the next channel in the bank. Repeat Steps 5 and 6 until all frequencies have been entered.

Step 7: Exit Programming Mode

To exit programming mode, press TRUNK. MANUAL will appear on the display.