Optocom Control Program
Version 2.1 Read Me File
6/23/99


Congratulations on the purchase of your new Optocom!

This utility program will allow you to control your Optocom
from any personal computer. Minimum system requirements
should be as low as a 286 with 1 meg of RAM. (Although it
has not been tested on a machine that slow.) 

With this utility you can set up your Optocom for Store and Scan mode,
and change the emulation mode from Optocom to Optoscan (OS535), and
control all the remote functions that the radio has.

While this program is written for DOS, it has been re-engineered
to be much more stable while running within Windows. 
However, be aware that if you get strange results while running within
Windows, it is best to reboot into DOS mode and try it there before
assuming something is wrong with either the software or hardware.
Possible problems that you may see while running within Windows could
include slow keyboard response, slow screen updates, and occasional
loss of communications which will cause the screen to reset back to 
the search screen for a second or so, then pop back up to normal.
For best results, if you wish to run within Windows, please make sure
that there are no other programs active at the same time.

If you have any questions about this software, please direct them
via email to support@optoelectronics.com. We regret that we cannot
provide technical support for this software by phone.

Please send bug reports to support@optoelectronics.com.


Version History
---------------

2.1 Restructured internal code to make it more efficient.
    Adjusted border slightly. 6-23

2.0 Redesigned interface, fixed comm engine routine problem
    that was causing random characters to appear in all the
    fields, adjusted timeout constant for better stability
    running within windows. 6/99

1.1 Removed visual and audible timeout indicators 1/99

1.0 Initial Release 11/98






