PRO-93 (200-0523) and PRO-95 (200-0525) Tutorial: How to Reset and Initialize the Scanner

The only difference between the PRO-93 and the PRO-95, is the number of channels each has; the PRO-93 having 300 channels and the PRO-95 having 1000. The method of programming for each is the same.

If the PRO-93 or PRO-95's scanner's display locks up or does not work properly after you connect a power source, you might need to reset or initialize it. This tutorial will explain How to Reset the Scanner and How to Initialize the Scanner.

For additional information on these products, see the links below:

PRO-93 User's Manual
PRO-95 User's Manual
General Scanner Basics
General Scanner FAQ
Scanner Tutorial Index Page[68853.htm - MISSING]

Reset the Scanner

If you have problems with the scanner, reset it first. All information stored in memory will remain.

Step 1: Power the Scanner Off, Then Back On




Rotate the OFF/VOLUME knob counter-clockwise to turn off the scanner, then clockwise to turn it back on again.



Step 2: Press the Reset Button



Insert a pointed object, such as a straightened paper clip, into the reset hole on the left side of the scanner above the PWR DC 9V jack.



Step 3: Reset the Scanner



Gently press and release the reset button inside the opening. NOTE: Pressing the reset button does not erase the scanner's memory.

Initialize the Scanner

This procedure clears all information you have stored in the scanner's memory.

Step 1: Power the Scanner Off, Then Back On



Rotate the OFF/VOLUME knob counter-clockwise to turn off the scanner, then clockwise to turn it back on again. Welcome To Dual Trunking displays.



Step 2: Intialize the Scanner



Press 0 then 1 while Welcome To Dual Trunking appears. Initializing Please Wait displays for about 2 seconds. NOTE: Do not turn off the scanner until the initialization is finished. When the initialization is finished, M000 displays on the top line and Bank 0 Ch 00 displays on the bottom line.

Back to top