LM611  Product Folder

The LM611 consists of a single-supply op-amp and a programmable voltage reference in one space saving 8-pin package. The op-amp out-performs most single-supply op-amps by providing higher speed and bandwidth along with low supply current. This device was specifically designed to lower cost and board space requirements in transducer, test, measurement and data acquisition systems.

Combining a stable voltage reference with a wide output swing op-amp makes the LM611 ideal for single supply transducers, signal conditioning and bridge driving where large common-mode signals are common. The voltage reference consists of a reliable band-gap design that maintains low dynamic output impedance (1Ohm typical), excellent initial tolerance (0.6%), and the ability to be programmed from 1.2V to 6.3V via two external resistors. The voltage reference is very stable even when driving large capacitive loads, as are commonly encountered in CMOS data acquisition systems.

As a member of National's Super-Block™ family, the LM611 is a space-saving monolithic alternative to a multi-chip solution, offering a high level of integration without sacrificing performance.

OP AMP

• Low operating current: 300 µA (op amp)
• Wide supply voltage range: 4V to 36V
• Wide common-mode range: V^- to (V⁺-1.8V)
• Wide differential input voltage: ±36V
• Available in low cost 8-pin DIP
• Available in plastic package rated for Military Temperature Range Operation

REFERENCE

• Adjustable output voltage: 1.2V to 6.3V
• Tight initial tolerance available: ±0.6%
• Wide operating current range: 17 µA to 20 mA
• Reference floats above ground
• Tolerant of load capacitance

• Transducer bridge driver
• Process and Mass Flow Control systems
• Power supply voltage monitor
• Buffered voltage references for A/D's